6 replies to this topic

[T.C.]

So, generally I just glue mesh to the top of my formicaria, however where can I get my hands on some nice vents, or sieves that look good? I don't have a 3D printer, but is there a place to buy this?

Also, if anyone here wants to make a buck, I am willing to let anyone with a 3D printer make me something like this. We can discuss the details via private message. I need alot.

Edited by T.C., February 20 2018 - 11:14 PM.

[starcraftjunkie]

what's the point of these?

 

IIRC my printer can't print lines with a gap between them smaller than around .8mm, so that's too big for most ant species

[gcsnelling]

If it were me I would go buy a couple of reusable coffee filters and cut the screen out for use.

[Hunter]

for mesh i use this https://nilesexpande...HoaAv7wEALw_wcB

[Kevin]

I am helping TC with this.

 

what's the point of these?

 

IIRC my printer can't print lines with a gap between them smaller than around .8mm, so that's too big for most ant species

 

Sorry to steer off topic, but you should check out this webpage: https://www.simplify...s-in-thin-walls

[SpikeyOls]

So, generally I just glue mesh to the top of my formicaria, however where can I get my hands on some nice vents, or sieves that look good? I don't have a 3D printer, but is there a place to buy this?

Also, if anyone here wants to make a buck, I am willing to let anyone with a 3D printer make me something like this. We can discuss the details via private message. I need alot.

 

If you drop me a PM with some specifications I will see what I can do   

[zlez93]

Try search push-fit vent reptile mesh.